A custom belt conveyor is only as good as the information behind the drawing. Confirming these parameters before fabrication avoids rework on belt selection, frame height and drive position.
Product and throughput
Record the largest and smallest item dimensions, unit weight, and how many items per hour the line must carry. These set belt width, belt strength and motor power. If products vary a lot, tell us the full range rather than an average, and mention whether the belt has to stop and start or index.
Belt and frame material
PVC suits general carton and part transfer; PU is preferred for food contact and oily conditions; rubber and canvas covers suit heavier or abrasive loads. Cleats and sidewalls are added for inclines. Frames are normally powder-coated carbon steel, stainless steel 304 for washdown areas, or aluminium profile where a light, modular structure is useful. JINDA builds belt widths from 500 to 1200 mm, with other widths on request.
Layout, drive and electrical standard
Confirm the straight length, any incline angle or turning section, working height at both ends, and where the motor can sit. End drive is common on straight runs; centre drive can help on long or reversible lines. State the voltage, frequency and phase of the destination country so the motor and controls are built correctly. Also note whether the conveyor must link to an existing line, since that fixes belt speed and height.
What to send with the enquiry
A simple dimensioned sketch, photos of the product and the installation area, and the parameters above are enough to start. We return a layout and specification for confirmation before production. The same checklist applies if you are replacing a belt on an existing conveyor.
See the belt conveyor category for the full product range, or contact us to discuss belt material options.
